Radius

The radius is one of the two bones of your forearm, the long bone on the thumb side. It runs from your elbow to your wrist, beside the ulna. Its upper end forms only a small part of the elbow joint, but its lower end is large and forms most of the wrist joint. When you turn your palm over, the radius turns around the ulna and carries your hand with it.

Where is the radius?

The radius lies on the thumb side of your forearm, and the ulna, the longer and larger of the two bones, on the little-finger side. Along their shafts, a thin sheet of fibrous tissue, the interosseous membrane, joins them.

To find the radius, feel for a small dimple just below the bony knob on the outer side of your elbow. That knob is the lateral epicondyle of the humerus, your upper arm bone. Put a finger in the dimple, bend your elbow halfway and turn your hand over and back. You'll feel the head of the radius, its top end, turning.

Muscles hide the upper half of the bone, but you can feel the lower half easily. Only a diamond-shaped patch of it lies right under the skin. It's on the thumb side of your wrist, at the base of the styloid process, the pointed tip of the bone's lower end.

What does the radius do?

The radius turns your forearm. Your hand is joined to the radius, not to the ulna, so it turns with the radius. When you turn your palm to face backward, the head of the radius spins in a ring at the elbow, and its lower end swings around the end of the ulna. The shaft of the radius is slightly curved, so its lower end crosses over the ulna and the two bones form an X. Turning your palm backward like this is called pronation. Turning it forward again, as when you scoop up soup with a spoon, is supination, which brings the bones back side by side.

The main muscles that turn your forearm all end on the radius. The pronator teres and the pronator quadratus turn your palm backward, and the biceps and the supinator turn it forward.

What are the parts of the radius?

The upper end

The head is shaped like a disc, with a shallow cup on top for the humerus and a smooth rim that turns against the ulna. Below the head, the bone narrows into the neck. Just below the neck, on the inner side, is the radial tuberosity, an oval bump where the tendon of the biceps attaches.

The shaft

The shaft is narrower at the top than at the bottom, and it bows slightly towards the thumb side. A ridge runs down its inner edge, facing the ulna. This is the interosseous border, where the interosseous membrane attaches.

The lower end

At the wrist, the radius widens into a large, four-sided end with two joint surfaces. The one underneath meets two of the carpal bones, the eight small bones of the wrist. These are the scaphoid, on the thumb side, and the lunate. The other, the ulnar notch, is a shallow hollow on the inner side that fits against the head of the ulna.

On the thumb side, the lower end comes to a point, the styloid process, where a forearm muscle, the brachioradialis, attaches. This point reaches further down than the styloid process of the ulna, which limits how far your hand can tilt towards the thumb side. On the back of the lower end, three grooves hold the tendons of muscles that straighten your wrist, thumb and fingers.

Which muscles attach to the radius?

Muscle Where it attaches
Biceps brachii The rough back part of the radial tuberosity
Supinator The upper third of the bone, which it wraps around
Flexor digitorum superficialis A slanting ridge high on the front
Flexor pollicis longus The upper three-quarters of the front
Pronator teres A rough ridge halfway down the outer side
Abductor pollicis longus The middle third of the back
Extensor pollicis brevis The back, just below the abductor pollicis longus
Pronator quadratus The lower quarter of the front
Brachioradialis The base of the styloid process

Which joints does the radius form?

At the elbow, the cup on the head of the radius meets the capitulum, the knob on the outer side of the lower end of the humerus. In the same joint, the rim of the head turns inside a ring. A notch in the ulna, the radial notch, makes part of the ring, and a strong band that circles the head, the annular ligament, makes the rest. This is the proximal radioulnar joint, a pivot joint, where one bone turns within a ring. The cup is shallow, so the head relies on the annular ligament to stay in place. Without the ligament, the tendon of the biceps could pull the head out of the joint.

At the wrist, the ulnar notch of the radius turns around the head of the ulna at the distal radioulnar joint, another pivot joint. A small triangular pad, the articular disc, binds the lower ends of the two bones together. It also keeps this joint separate from the wrist joint.

How do radius fractures happen?

A fracture is a broken bone. Many happen in a hard fall onto an outstretched hand, when the force travels up the arm and can break the radius, the humerus or the scaphoid. These breaks are especially common in older people whose bones have been weakened by osteoporosis.

The most common break of the forearm is a Colles fracture (say col-lees), another frequent result of a fall onto an outstretched hand. The lower end of the radius breaks straight across, and the lower piece is driven backward and upward. The hand moves back with it, which gives the forearm a bend just above the wrist shaped like a dinner fork. A Colles fracture is a common injury in people over 50, especially older women with osteoporosis. It also often follows a fast fall onto the hand, as in snowboarding or skating.

Every fact checked against the sources below on

Test yourself

Which two wrist bones meet the lower end of the radius?

Sources