Ulna

The ulna is the bone on the little-finger side of your forearm. It's a long bone that runs from your elbow to your wrist, beside the radius. Its thick upper end forms a large part of the elbow joint, where a C-shaped notch in it holds the lower end of your upper arm bone, the humerus. The point of your elbow is the top of the ulna.

Where is the ulna?

The ulna lies on the little-finger side of your forearm, parallel to the radius, and it's the longer of the two bones. It's thick and strong at the elbow and thins towards the wrist.

You can feel the ulna along its whole length. Start at the point of your elbow, the olecranon. Follow the back border of the bone down the back of your forearm to a small bump on the little-finger side of your wrist. That bump is the styloid process of the ulna. Turn your palm down, and a second bump, the head of the ulna, shows just behind and above it.

What does the ulna do?

At the elbow, the ulna and the humerus form a hinge. The ulna's C-shaped notch fits around the trochlea, a part of the humerus's lower end shaped like a pulley, so closely that the joint can't move from side to side. This hinge can only bend and straighten.

Two of the main muscles that move the elbow end on the ulna. The triceps attaches to the olecranon and straightens your elbow. The brachialis attaches to the coronoid process, a lip of bone at the front of the ulna, and bends your elbow.

Many forearm muscles start from the ulna. Among them are the flexor digitorum profundus, which bends your fingertips, and deep muscles that move your thumb and index finger.

What are the parts of the ulna?

The upper end

The top of the ulna looks like a wrench, with a large C-shaped notch, the trochlear notch, between two curved pieces of bone.

The olecranon is the thick, curved piece at the top and back, the point of your elbow. Its tip bends forward into a lip, and when you straighten your arm, the lip fits into a hollow on the back of the humerus. The back of the olecranon is smooth and lies just under the skin, with a bursa, a thin sac of fluid, over it.

The coronoid process is a triangular lip of bone that juts forward and forms the lower edge of the notch. Its tip fits into a small hollow on the front of the humerus when you bend your elbow fully. The brachialis attaches to the front of the coronoid process and to the ulnar tuberosity, a rough patch just below it.

On the outer side of the coronoid process is the radial notch, a narrow, smooth hollow where the head of the radius turns.

The shaft

A ridge runs down the thumb side of the shaft, facing the radius. This is the interosseous border. The interosseous membrane, the sheet of tissue that ties the ulna to the radius, attaches along it. The back border of the shaft is the ridge you can feel down the back of your forearm.

The lower end

The small lower end has two bumps. The larger one, on the thumb side, is the rounded head of the ulna. Its side fits into the ulnar notch, a hollow on the radius, and its underside rests on the articular disc, a small triangular pad. The smaller bump, towards the back and the little finger, is the styloid process, which reaches a little lower than the head. Behind, a shallow groove between the head and the styloid process holds the tendon of the extensor carpi ulnaris, a muscle that straightens your wrist.

Which muscles attach to the ulna?

Muscle Where it attaches
Triceps brachii The top of the olecranon, at the back
Anconeus The outer side of the olecranon and the upper quarter of the back
Flexor carpi ulnaris The inner edge of the olecranon and the upper two-thirds of the back border
Brachialis The front of the coronoid process and the ulnar tuberosity
Pronator teres A ridge on the inner side of the coronoid process
Flexor digitorum superficialis A small bump on the inner side of the coronoid process
Supinator A slanting ridge and a hollow just below the radial notch
Flexor digitorum profundus The upper three-quarters of the front and inner side
Extensor carpi ulnaris The back border
Abductor pollicis longus The back, below the anconeus
Extensor pollicis longus The middle third of the back
Extensor indicis The back, below the extensor pollicis longus
Pronator quadratus The lower quarter of the front

Which joints does the ulna form?

The ulna has joints with two bones, the humerus and the radius. At the elbow, the ulna's trochlear notch meets the trochlea of the humerus in a hinge joint. In the same joint, the radial notch holds the head of the radius at the proximal radioulnar joint. This is a pivot joint, where the radius turns within a ring of bone and ligament.

At the wrist, the head of the ulna sits in the ulnar notch of the radius at the distal radioulnar joint. This is another pivot joint, where the radius moves around the ulna. The ulna doesn't meet any of the wrist bones. The articular disc lies between them, so your hand joins the radius alone.

Along their shafts, the interosseous membrane joins the ulna to the radius and still lets the radius turn.

What injuries involve the ulna?

In children, a fall onto the tip of the elbow often drives the olecranon upward and breaks the humerus across its lower end. The break runs above or between the epicondyles, the bony knobs on either side of the elbow.

When a forearm bone breaks, the interosseous membrane between the ulna and the radius can tear as well. Damage there causes pain, makes the bones less stable and may harm the muscles attached to the membrane.

The bursa over the olecranon can become inflamed. This is olecranon bursitis, also called student's elbow, and it causes pain, swelling or tenderness.

Every fact checked against the sources below on

Test yourself

What keeps the lower end of the ulna out of the wrist joint?

Sources